Avintage AVI82CDZA Manual De Utilización página 52

AVI94X3Z

Upper and middle compartments of your wine cellar

Lower compartment of your wine cellar
1) " " button
To turn the appliance on or off.
Press and hold this button for around 5 seconds.
2) " " button
To turn the inner light on or off.
3) " " button
Press this button, and temperature will increase by 1°C or 1°F.
4) " " button
Press this button, and temperature will decrease by 1°C or 1°F.
The temperature range of this cellar is between 14°C and 18°C in upper compartment, between 5°C
and 11°C in the middle one and between 11°C and 13°C in lower compartment.
To change the temperature reading unit, press the light button (1) for 5 seconds. The display will show
the selected temperature unit (°C or °F).
Temperature display
In normal operation, the display shows the temperature inside the cellar. When you increase or
decrease this temperature, the display will show the desired temperature. After a few moments, the
display will again show the temperature measured in the cellar. The temperature display will flash if:
A different temperature is being set,
-
The temperature in the zone deviates by more than 5°C from the set temperature. The
-
temperature display flashing ensures that the temperature cannot rise or fall un-noticed and
impair the wine.
NOTE: when first used or after operating the wine cellar after a long period of inactivity, the inner
temperature will not immediately be the temperature shows on the display. Indeed, it is necessary to
wait a few hours for a temperature adjustment of the wine cellar in order to have a homogeneous
temperature. To avoid excessive condensation when the ambient temperature is above 28°C, do not
lower the temperature to below 7°C.
IMPORTANT: after unplugging, turning off the power or after a power failure, it is imperative to
wait 5 minutes before turning it on again. Otherwise, the wine cellar will not turn on.
52