CASO DESIGN TO 32 Classic Manual Del Usuario página 33

13.3 Unpacking
Remove the device out of the carton, remove the packaging material, shovel and measuring
container.
13.4 Disposal of the packaging
The packaging protects the device against damages during transit. The packaging materials
are selected in accordance with environmentally compatible and recycling-related points of
view and can therefore be recycled.
Returning the packaging back to the material loop saves raw materials and reduces
the quantities of accumulated waste. Take any packaging materials that are no
longer required to "Green Dot" recycling collection points for disposal.
Please note
► If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event of
a guarantee claim.
13.4.1 Setup location requirements:
In order to ensure the safe and trouble-free operation of the device, the setup location must
fulfil the following prerequisites:
• Place the device on a firm, flat, level and heat-resistant surface with sufficient load-
bearing capacity for the device and its contents.
• Dot not place the device on a metal surface.
• Choose the setup location in such a way that children cannot reach any hot surfaces on
the device.
• The device is not intended to be installed in a wall or a built-in cupboard.
• Do not set up the device in a hot, wet or extremely damp environment or near flammable
material.
• Do not place the device near a gas or electric cooker or an oven.
• The device requires an adequate flow of air in order to operate correctly. Make sure that
the back of the device is at least 10 cm away from the wall. Keep 20 cm free space at the
other sides of the device.
• Do not cover up any openings on the device and do not block these off.
• The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
• The device and power cord should not come in contact with hot surfaces. The device
could be damaged.
• The installation and assembly of this device in non-stationary setup locations must be
carried out by specialist companies / electricians, provided they guarantee the
prerequisites for the safe use of this device.
33