Lindy 38334 Manual De Usuario página 4

User Manual
Installation
Front Panel
1. OLED Screen – Displays the Input and Output status of the matrix. Also displays the EDID
management and the matrix's IP address when required.
2. Power LED – The LED will be illuminated green when the matrix is powered on. The LED will be
illuminated red when the matrix is in standby.
3. Input / Output Buttons – First press an output button followed by an input button to relay the input
to the chosen output.
4. Menu / Enter / Up / Down Buttons – Switch between different information like EDID, IP Address,
Baud rate and current matrix setup.
5. Power Button – Press and hold this button to power on/off the Matrix.
6. IR Window – Receives the IR signal from the included IR remote for control over the entire
installation.
7. Lock Button – Press this button to lock/unlock the front panel buttons.
Rear Panel
1. IR EXT Port – Using the included IR extension cable, please place the IR eye in a clear line of
sight. For use when the matrix's main IR eye is out of sight.
2. L/R Out (1-8) – Extract HDMI output audio to separate amplifiers or speakers.
3. Coax Out (1-8) – Extract HDMI output audio to separate amplifiers or speakers with coaxial cable
4. TCP/IP Port – Connect to a network or network switch using a Cat. X cable.
5. RS-232 Port – Connect to a PC or control system using an RS-232 cable.
6. GND – Connect the GND to the ground reference point.
7. Input Ports – Connect to an HDMI source device using an high quality HDMI cable.
8. Output Ports – Connect to an HDMI display, splitter or extender using an high quality HDMI cable.
9. DC 12V – Connect to the included 12VDC 3A PSU and screw to secure. Plug into an AC wall outlet
to power the matrix.
English