Publicidad
Idiomas disponibles
Idiomas disponibles
User Manual
Operation
IR Remote
The output must be selected first, then the input port to display the set
layout.
1. Power Button – Power on the matrix or press to set the matrix
to standby.
2. Input Selection – Press to select the required Input port.
< >: Press to select the previous or the following Input port.
3. Output Selection – Press to select the required Output port.
All: Press to output to all Output ports simultaneously from the
selected source.
Web-GUI
This matrix can be easily controlled via Web-GUI software. Please ensure the IP address of the matrix is
noted. This can be found using the push buttons on the front panel, please refer to the Front Panel
description above for this. The static IP address is 192.168.1.100. The Matrix can be connected to a PC
with a standard Cat.X cable.
The factory default is set to DHCP, so the Web-GUI can be opened by entering the IP address into any
browser. If DHCP is turned off you have to set the control PC to the same IP range as the Matrix.
The default logins are:
After the login the Status Page will appear. On the left side you can switch between the different functions.
Status Page:
It provides basic network and general information, like the installed firmware version or MAC-Address.
Video Page:
Here you can select and switch the input for each individual output. It also allows the storage of up to 8
different pre-sets.
Username: User, Password: user
Username: Admin, Password: admin.
English
Publicidad
