Urmet Vmodo SOFT TOUCH 2VOICE 1719/1 Manual De Instalacion Y Uso página 20

BUTTON FUNCTION
FUNCTIONS
Function 1*
Function 2
Function 3
Function 4
* Default configuration
To changing the function of a button:
1 - Briefly press any button on the video door phone (Yokis Configuration Menu) 10 times. The video door
phone LED will blink rapidly.
2 - While the LED is blinking, press the chosen button from 1 to 4 and select the desired function: from 1
to 4, see above.
3 - The LED will blink from 1 (or 4) times to confirm calibration.
Restoring a video door phone Yokis Button to default settings
Default setting = delete button connections, return to function 1 (bistable), return to direct mode.
1 - Briefly press either Yokis button (Yokis Configuration Menu) 10 times. The video door phone LED will
blink rapidly.
2 - While the LED is blinking, rapidly press the button that you want to return to default setting 15 times.
3 - After pressing 15 times, the LED will blink 5 times to confirm.
Complete restore of the two video door phone Yokis buttons to default settings
1 - Briefly press either Yokis button (Yokis Configuration Menu) 10 times. The video door phone LED will
blink rapidly.
2 - While the LED is flashing, press either of the two Yokis buttons 25 times.
3 - After pressing 25 times, the LED will flash to confirm that default settings have been restored.
For more information and detailed configurations, consult the documentation on the two-button remote
controls on the www.yokis.com website.
CALL REPEAT FUNCTION FOR HEARING-IMPAIRED USERS WITH
YOKIS MODULE
The video door phone, connected to a Yokis MTR2000ERP relay module, can be used to repeat a call by
switching the relay (e.g. by making a light bulb blink) when the video door phone receives a call from the
door unit, from the switchboard, from another video door phone (intercom) or from the floor.
Follow the instructions in the chapters below to configure and activate this function.
1. WIRELESS CONNECTION BETWEEN VIDEO DOOR PHONE AND YOKIS
MODULE
• Press the button briefly 5 times (*).
• The Yokis LED
is waiting for a connection.
(*) Each touch must be less than 0.7 seconds long.
• While the Yokis
front or back of the receiver) with a pointed, adequately insulated tool. The LED on the video door phone
will stop blinking.
Important: The receiver must be powered.
2. PROGRAMMING THE BLINKING
• Press the button 10 times.
The Yokis LED
• While the Yokis LED
• The Yokis LED on the video door phone will flash 9 times to confirm programming.
20
MTR2000ERP
Power on / off
-
On
Off
on the video door phone will start blinking for 30 seconds, indicating that the device
LED is blinking, briefly press in the "Connect" hole of the receiver (located at the
on the video door phone will start blinking quickly.
on the video door phone is blinking, press the button 19 times.
MTV500ERP
Change / off
Memory on
On
Off
MVR500ERP
Up / stop / down
Intermediate position
Up / Stop
Down / Stop
DS1719-004A