Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
You must place the grilles before operating
the fan.
Warning: Never operate the fan without its
base or other parts.
Operate the fan only in an upright position;
any other position could create a dangerous
situation.
Assemble the base and other parts of the
appliance considering the following notes.
Note: the images are for guidance only and
should be used to support the installation.
See the image sequence on picture 02 on
page 5.
• The base has two parts, A, back part
and B, front part.
•
• First, insert part A so that the arrows (C)
fit in the gaps (D)
• The cable must be as displayed on
image E.
• Now insert part B so that the arrows (F)
fit the gaps (G). Besides, the protruding
parts (H) must be fitted into the back
part (A), and the arrows (I) on the back
part (A) must hold the front part (B)
• Make sure the cable is nested in the
correct position and does not affect the
stability of the product.
USING THE APPLIANCE
This device is easy to use and does not
require much knowledge. However, we
advise you to familiarize yourself with the
instructions below.
(
Control panel
see picture 03 on page 6)
6. Speed knob: turn the knob to set the
speed.
• J) Choose these positions if you do
not want the product to oscillate.
• K) Choose these positions if you
want the product to oscillate.
• Note that 1 is low speed, 2 is medium
speed and 3 is high speed.
7. Timer knob: turn the knob to select
the timer. You can select from 0 to
20
120 minutes. Keep in mind that if
you select the "OFF" position, the fan
will operate without the timer and
therefore it will not turn off until the
speed is set to 0.
CLEANING AND MAINTENANCE
Para limpiarlo, por favor siga las siguientes
instrucciones:
• Turn the fan off and wait until it has
stopped completely.
• Disconnect it from the power supply.
• Be careful to prevent any liquid from
getting inside the appliance.
• Use only a soft damp cloth.
• Do not allow water at a high temperature
in contact with the plastic parts.
• Do not use abrasive cleaners. You can
use a neutral detergent.
• When you have finished cleaning it,
assemble it again and store it in a dry
place.
• If you are not going to use the fan
for some time, it is recommended to
remove the batteries from the remote
control and store it in a clean and dry
place.
Follow these indications in order to
optimize the maintenance:
• To clean the fan externally, use a soft
cloth immersed in water at 40°.
• Do not use sharp or hard objects to
scratch
the
ceramic part for transduction. It can
only be cleaned with a soft, damp cloth.
• Do not use a cloth with a chemical
solvent, gasoline, kerosene, or polishing
powder to clean the surface.
• Do not use random detergent for
cleaning. It is best to use clean water.
• Keep water away from the body of the
machine to prevent moisture from
internal electrical components that can
cause malfunction.
• Readjust the visible screws from time
to time to ensure a good performance of
the appliance.
vibrating
piezoelectric
Publicidad
