Chicago Pneumatic CP 0122 SVR Instrucciones De Seguridad Y De Funcionamiento página 17

CP 0122 SVR, CP 0125 SVR
♦ For the machine to maintain the specified
vibration values, always check the following:
Too large a clearance between the insertion tool s
shank and the chisel bushing will generate
increased vibrations. To avoid getting exposed to
excessive vibrations, check the chisel bushing for
wear every day.
If the machine has a vibration-absorbing
♦
handle/handles, check that it moves freely (up
and down) and does not jam.
Change damaged parts immediately.
♦
Replace worn components in good time.
♦
Make sure that all the attached and related
♦
equipment, such as hoses, water separators and
oilers are properly maintained.
Periodic maintenance
After each operating period of approximately 100
impact hours or three times a year the machine must
be dismantled and all parts be cleaned and checked.
This work must be performed by authorized staff,
trained for this task.
9800 0834 90b | Original instructions
www.CrowderSupply.com • Toll Free: 888-883-5144
Safety and operating instructions
Assembly instructions
A. Torque: 11-12 lbf/ft (15-17 Nm), UNF ¼"x44
(1-¾")
Torque: 11-12 lbf/ft (15-17 Nm), UNC ¼"x32
B.
(1- ¼")
Torque: 45-50 lbf/ft (61-68 Nm). Use Loctite®
C.
243™. (Loctite is a registered trademark of
Henkel Corporation. 243 is a trademark of
Henkel Corporation.)
D. Torque: 12 lbf/ft (17 Nm). Use Loctite® 243™.
E. Remove the O-ring from the seal before
assembly. The O-ring is only a support to
ensure that the seal retains the correct shape
until it is fitted.
Do not lubricate support rollers, wear ring, or
F.
corresponding contact surfaces.
Torque: 400 lbf/ft (540 Nm).
G.
17