Descargar Imprimir esta página

Husqvarna 960430242 Manual Del Operario página 22

Publicidad

Idiomas disponibles

Idiomas disponibles

SERVICE AND ADJUSTMENTS
From right side of mower, fi rst insert 90° end of anti-sway
bar (S) into hole in transaxle bracket (T), located near
left rear tire in front of transaxle.
NOTE: Flashlight may be helpful.
ANTI-SWAY BAR
(S) LOCATION
T
NOTE: Depending on model, bracket (T) may be differ-
ent than shown but hole for anti-sway bar will be in same
position/location.
Pivot the integrated washer end of anti-sway bar (S)
towards mower deck bracket on right side of mower.
Insert integrated washer end of bar into hole in rear
mower bracket (D). Move mower as needed to insert
integrated washer end of bar into rear mower bracket (D).
Secure with small washer and small retainer spring as
shown.
S
T
D
ATTACH MOWER SIDE SUSPENSION ARMS (A) TO
CHASSIS - Position hole in arm over pin (B) on outside
of tractor chassis and secure with retainer spring.
Repeat on opposite side of tractor.
A
TRANSAXLE
BRACKET (T)
LOCATED
BETWEEN REAR
TIRES
S
S. ANTI-SWAY BAR
T. TRANSAXLE BRACKET
Fig. 27
D. RIGHT SIDE
REAR MOWER
BRACKET
S. ANTI-SWAY BAR
T. TRANSAXLE
BRACKET
Fig. 28
B
Fig. 29
ATTACH REAR LIFT LINKS (C) - Lift rear corner of
mower and position slot in link assembly over pin on
rear mower bracket (D) and secure with washer and
retainer spring.
Repeat on opposite side of tractor.
D
ATTACH FRONT LINK (E) - Work from left side of trac-
tor. Insert threaded rod end of link assembly through
front hole in tractor suspension bracket (F).
Install bushing (O) and loosely install nut (P) and jam
nut (Q).
Insert fl ared ends of link (E) into slots in front mower
bracket (H).
Check Front-To-Back Adjustment in "TO LEVEL
MOWER" in this section.
H
Install belt onto electric clutch pulley (M).
M
IMPORTANT: CHECK BELT FOR PROPER ROUTING
IN ALL MOWER PULLEY GROOVES.
Raise attachment lift lever to highest position.
If necessary, adjust gauge wheels before op er at ing
mower as shown in the Operation section of this manual.
See Mower Drive Belt Installation in "TO REPLACE MOWER
BLADE DRIVE BELT" in this section of the manual.
22
C
Fig. 30
F
O
P
E
Fig. 31
Fig. 32
Q

Publicidad

loading

Este manual también es adecuado para:

Ts 348xd960430289960430319960430320