Publicidad
Idiomas disponibles
Idiomas disponibles
40" DUAL FUEL RANGE INSTALLATION INSTRUCTIONS
6
Install the Oven Racks
The oven racks are supported inside the oven cavity by
two ladder racks, installed on the oven walls.
1. Place the ladder racks hook-side up into the support
brackets located on the oven sides (see Figure 11).
Figure 11: Ladder rack supports
2. Place the flat oven racks into the desired positions.
To aid installation and movement of oven racks, apply
a thin layer of cooking oil to the sides of the oven racks
that contact the ladder supports.
7
Level the Range
Level the range and set cooktop height before
installation in the cut-out opening (if applicable).
1. Install an oven rack in the center of the oven.
2. Place a level on the rack (Figure 12). Take two
readings with the level placed diagonally in one
direction and then the other.
Figure 12: Use the oven racks to level appliance
3. Level the range, if necessary, by adjusting the four
leg levelers with a wrench (Figure 13).
4. Slide range into cut-out opening and double check
for levelness. If the range is not level, pull unit out
and readjust leveling legs, or make sure floor is level.
Leg
Leveler
Raise
Lower
Figure 13: Adjusting appliance height
11
Publicidad
