Publicidad
Idiomas disponibles
Idiomas disponibles
*Always follow manufacturer instructions*
BM 1609929J65 01-11:BM 1609929J65 01-11 1/20/11 10:41 AM Page 12
ABRASIVE TyPE 1A & 27A
WHEEL ASSEMBLy
(Models 1810PS, 1810PSD, 1811PS,
1811PSD &1812PSD only)
Using the optional type 1 wheel guard
(supplied with 1812PSD only), it is possible
to perform limited cutting on small stock such
as metal tubes, piping or rebar.
Do not attempt to cut large stock or sheets of
metal as this tool is not designed to be a
dedicated cutting tool.
Always use type 1 protection
WARNING
guard for cutting.
Disconnect tool from power source. Be sure
that wheel guard is in place for cutting.
When using mounting wheels, thread
BACKING FLANGE onto spindle, then place
WHEEL on the spindle. Thread on the lock
nut and tighten nut using a lock nut wrench
provided with adapter kit, while holding the
spindle lock in (Fig. 5).
TO REMOVE: Reverse procedure.
TyPE 1 ABRASIVE
STRAIGHT GRINDING WHEELS
Do not use type 1 abrasive
WARNING
wheels
straight/die grinding. This tool is not
designed for use with type 1 abrasive
straight/die grinding wheels.
SANDING ACCESSORIES ASSEMBLy
BACKING PAD
Before attaching a backing
WARNING
pad be sure its maximum
safe operating speed is not exceeded by the
nameplate speed of the tool.
Wheel guard may not be
WARNING
used for most sanding
operations. Always reinstall wheel guard
when converting back to grinding operations.
TO INSTALL BACKING PAD AND
SANDING DISC
Disconnect tool from power source.
Attach hand guard (Fig. 1). Set the tool on its
top side (spindle up). Place the rubber
backing pad onto the spindle shaft. Center
the sanding disc on top of the backing pad.
Insert the lock nut through the disc and
thread onto the spindle as far as you can with
your fingers. Press in the spindle lock, then
tighten the backing pad securely with lock nut
wrench (Fig. 6).
TO REMOVE: Reverse procedure.
TYPE 1A
designed
for
-12-
*AAA Rent-All 225-291-1356*
FIG. 5
SPINDLE
BACKING
FLANGE
LOCK NUT
WHEEL
FIG. 6
WIRE
BRUSH
TYPE 1
WHEEL GUARD
(Included with model
1812PSD only)
TYPE 27A
WHEEL
SPINDLE
BACKING
PAD
SANDING
DISC
LOCK NUT
Publicidad
