Publicidad
Idiomas disponibles
Idiomas disponibles
(17) By-pass lever – free movement of the rear wheels
The by-pass lever serves to disengage the transmission for the rear wheel drive and is used to push or pull the machine
without using the engine. The lever is located on the rear side of the machine and has the following two positions:
ATTENTION! The by-pass lever is primarily used to bleed air from the hydrostatic system. Due to the
high demands on equipment, have this procedure performed by a specialised service centre.
The machine must not be used (gear shifted into drive) if the by-pass lever is in the disengaged position
- there is a danger of damage to the transmissions!
Rear wheel
Position
drive
(0)
DISENGAGED
(1)
ENGAGED
83
Use
Lever is extended - for pushing the machine
Lever is inserted - for driving the machine
Publicidad
