Rocal DROP X1320 Manual De Caracteristicas, Instalacion Y Funcionamiento página 15

6. PROBLEMS: CAUSE AND SOLUTION
Below is a table of possible anomalies, their causes and solutions:
PROBLEM CAUSE
1. Rejects smoke Incorrect duct
and / or
insufficient
draught
Lack of air supply for combustion
Incorrect position of registers
2. Excessive dirt Incorrect duct
on glass
Inappropriate fuel
Overly closed registers
3. Glass Excessive temperature caused
bleaching or by
colour fading of combustion chamber
the plate
4. Poor heating Inappropriate fuel
Insufficient load
Combustion control registers in
the wrong position
5. Venting smoke First lighting
and / or gases
from the front,
bad smell Flammable or combustible items
in the enclosure or surrounding
walls of the equipment
Crack
chamber of the equipment
6. Excessive draft Incorrect duct
Combustion control registers in
the wrong position
7. Poor draft
Incorrect duct
Duct dirtiness
excessive heat in
in the combustion
SOLUTION
Duct servicing*:
-connection
-diameter
-leaks
-insufficient length
-outdoor access
-possible elements blocking the exit
Check vents and / or outside air supply.
Simultaneous operation with other ventilation devices and / or
heating
Setting the register
Revise section on insufficient flue (below).
Use recommended fuel
Adjust registers
Check the fuel load avoiding overheating
the
Adjust registers
Use recommended fuel
Adding fuel
Adjust registers
Wait for the polymerization process of the paint to finish; this
can take from one to several lightings.
Review of insulating materials such as fiberglass, fireproof
wood or any inflammable elements and replace them.
Check for tightness and if you discover a crack, please contact
your dealer.
Duct servicing
- Excessive length
- Check Depression
- Incorrect diameter
- Check door gasket
Open the primary and secondary register following the steps
outlined in the manual. Should this not have an effect, check
that the flue duct is clean; if it is not clean, contact a professional
to clean this. If the problem persists contact your dealer.
pag. 14