Publicidad
Idiomas disponibles
Idiomas disponibles
∙ During this time, use the replacement filters provided if necessary.
∙ Reinstall the dry filters as described under "Assemble the dust container".
Motor pre-filter:
∙ Take out the dust container and then take the motor pre-filter out of the appliance.
∙ The filter is washable (max. 40 °C), but neither dishwasher nor washing machine safe.
∙ Rinse the filter thoroughly under running water.
∙ After cleaning, leave it to dry at room temperature for about 24 hours. Only put it back when it is completely dry.
HEPA filter:
∙ Open the HEPA filter cover and take the filter out.
∙ First tap out the filter and then brush it out. Then tap out any loosened dust residues again.
∙ The HEPA filter is not washable.
∙ Put the filter back in and close the cover.
Cleaning
∙ The housing and power cable may not be handled with liquids or immersed in liquids for reasons of electrical safety. Rub
housing with a slightly damp cloth and then dry.
∙ For cleaning, do not use any sharp or scouring cleansers or hard brushes.
Storing the appliance
∙ For easy storage when not in use, the floor nozzle can be hooked into the park hook above the cover of the HEPA filter.
∙ To avoid any problems, it is important to empty the dust container regularly and to take this opportunity to check the filters
and clean or replace them depending on how dirty they are.
∙ Before contacting our customer service, check with the help of below table whether you can correct the problem yourself.
Problem
The appliance stops
suddenly
The appliance hardly
picks up any dust and/or
the suction power drops
Odours spread or even
dust escapes from the
appliance
∙ If this does not help, please contact our customer service.
16
Troubleshooting by yourself
The integrated overheating protection has responded (possibly due to an overfilled dust
container or similar) In this case, proceed as follows:
1.
Switch off the appliance.
2.
Pull plug from main socket.
3.
Eliminate the cause of overheating (either the dust container needs emptying - see the
section on "Emptying the dust container", or the filters need cleaning - see the section
on "Cleaning or replacing the filters" or there is a blockage somewhere, which needs to
be removed).
4.
Include the suction hose, nozzle, and tube and search for the cause of the overheating.
5.
Close the cover and re-fit all accessory.
6.
Wait another 45 minutes.
After the appliance has cooled off, you may switch it on again.
The dust container needs to be emptied (see the section on "Emptying/cleaning the dust
container").
It is advisable to take this opportunity to clean the filters at the same time (see "Clean or
replace the filters").
With the switchable floor nozzle attached, the switch is not in a position appropriate to the
type of floor.
Select the correct position for the switch.
It is likely that parts of the dust container or vacuum cleaner accessories that were
dismantled to clean the filter or change accessories were not properly reinstalled or closed.
Check that all parts are correctly and firmly in place.
Solution
Publicidad
