Publicidad
Idiomas disponibles
Idiomas disponibles
Note : the Fuel cup seal and bolt seal may be damaged during removal and should be replaced with
the new ones from the kit.
7.Reassemble the Fuel Cup Seal , fuel cup , Bolt seal and bolt . Tighten in place
8. Wipe up any spilled fuel and allow excess to evaporate before starting engine . To prevent FIRE ,
do not start the engine while the smell of fuel hangs in the air .
WARNING! To prevent serious injury from fire: Follow the kit procedures in a
well-ventilated area away from ignition sources. If the engine is hot from use, shut the
engine off and wait for it to cool before proceeding.
NOTICE: The warranty may be void if necessary adjustments are not made for high altitude use.
STOP THE ENGINE
Release the engine start/stop control to stop the engine.
MOWING
The engine throttle on your mower has been preset to provide optimum bagging and mulching
performance for years to come.
Only use a sharp blade that is in good condition. This will prevent the grass blades from becoming
frayed and the lawn from turning yellow.
Mow in straight lines for a nice, clean look. The swaths should overlap each other by a few inches in
order to avoid stripes.
It's important to keep the underside of the mower deck clean and remove grass build-up. This buildup
will decrease mulching quality, and make it harder for the equipment to bag the grass.
Always mow along inclines (not up and down). You can prevent the lawn mower from slipping down
by holding a position at an angle upwards. Select the cutting height according to the length of the
grass. If necessary, mow a number of times so that you never cut more than 2 inches of grass in one
go.
Turn off the engine before doing any checks on the blade. Keep in mind that the blade continues to
rotate for a few seconds after the engine has been turned off. Never attempt to manually stop the blade.
Regularly check to see if the blade is securely attached, is in good condition and is sharp. If the
contrary is the case, sharpen the blade or replace it. In the event that the blade strikes an object,
immediately turn off the lawn mower and wait for the blade to come to a complete stop. Then inspect
the condition of the blade and the blade mount. Replace any parts that are damaged.
USING AS SIDE DISCHARGE
You should close the rear cover with mulching adapter in order to use the side discharge.
1. On the side of the mower, lift the side discharge cover.
2. Slide two hooks of side discharge chute under hinge pin on the side discharge cover. Lower the
side discharge cover.
Part
Description
1
Main Jet 3000-6000 ft.
2
Main Jet 6000-8000 ft.
3
Bolt Seal
4
Fuel Cup Seal
17
Qty
1
1
1
1
Publicidad
