Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
14
Problem
Possible cause
The ironing board
Steam has condensed on the
cover becomes
ironing board cover after a long
wet or there are
ironing session.
water droplets on
the garment during
ironing.
You have an ironing board cover
that is not designed to cope
with the high steam rate of the
appliance.
Water droplets come
The steam that was still present
out of the soleplate.
in the hose has cooled down
and condensed into water. This
causes water droplets to come
out of the soleplate.
Storage
1
Switch off the appliance and unplug it.
2
Remove the water tank and empty it.
3
Put the iron on the iron platform. Push the carry lock to lock the iron
onto the platform.
4
Fold the supply hose and mains cord. Put them in their respective
storage compartments.
5
You can carry the appliance with one hand by the handle of the iron.
Do not carry the appliance by holding the water tank release lever.
Troubleshooting
This chapter summarises the most common problems you could encounter
with the appliance. If you are unable to solve the problem with the
information below, visit www.philips.com/support for a list of frequently
asked questions or contact the Consumer Care Centre in your country.
Solution
Replace the ironing board cover if the foam
material has worn out. You can also add an
extra layer of felt material under the ironing
board cover to prevent condensation on the
ironing board. You can buy felt in a fabric
shop.
Put an extra layer of felt material under the
ironing board cover to prevent condensation
on the ironing board. You can buy felt in a
fabric shop.
Steam away from the garment for a few
seconds.
Publicidad
