GE AEM18 Serie Manual Del Propietario Y Instrucciones De Instalación página 12

PREPARE THE WinDoW AnD inSTALL
5
THE CASE (continues)
H CAuTion:
To prevent broken
glass or damage to
windows, on vinyl or
other similarly
constructed windows,
attach the window
locking bracket to the window side jamb.
Attach the window locking
bracket with one Type C
screw .
This unit contains two
window locking brackets .
Cut the foam top window gasket to the
I
window width.
J
Stuff the foam
between the
glass and the
window to
prevent air and
insects from getting into the room.
NOTE: If the gasket supplied does not fit
your window, obtain appropriate material
locally to provide a proper installation seal.
INSTALL THE AIR CONDITIONER
6
IN THE CASE
Slide the air conditioner into the case by
A
the base pan. Do not push on the controls,
styrofoam air discharge housing or the finned
coils. Make sure the air conditioner is firmly
seated.
Base Pan
installation instructions
Vinyl
Wood
Do not press on
these areas—
damage to the unit
may result
12
INSTALL THE AIR CONDITIONER
6
IN THE CASE (continues)
Replace the 1 screw removed earlier, one
B
on each side of the case.
iMPoRTAnT: THE gRounD SCREWS MuST BE
REinSTALLED To EnSuRE PRoPER gounD.
Reinstall the control to the panel housing by
C
replacing the 2 screws you removed earlier.
Install Screws
Attach the front grille to the case by inserting
D
the tabs on the grille into the slots on the
front top of the case. Push the grille in.
Replace the screws.
E
Install the filter and the front grille.
F
Plug in the air conditioner.
F