Global Industrial 292850 Manual Del Usuario

User's manual
Customer Service
US: 1-800-645-2986
WARNING
Read all instructions before use. To reduce the risk of
fire, electric shock, or injury to persons when using this
appliance, follow the following precautions:
• Two people are recommended to lift and install the unit.
• Remove all packing materials from the air conditioner
before use.
• Make sure the air conditioner is the correct size for the
area you wish to cool.
• Install the air conditioner on a sturdy, level floor capable
of supporting up to 110 lbs. Installation on a weak or
unleveled floor can result in the risk of property damage
and/or personal injury.
• DO NOT operate air conditioner without the filter
securely in place. Operation without the filter could
damage the unit.
• DO NOT position the air conditioner so that pets or
house plants are exposed to the direct air flow.
• DO NOT attempt to repair or replace any part of your
air conditioner unless it is specifically recommended in
this manual. All other services should be referred to a
qualified technician.
• DO NOT use if the power cord is worn or damaged.
Power cords should only be replaced by qualified
service technicians using genuine replacement parts.
• ALWAYS Plug the air conditioner firmly and completely
into its own grounded circuit.
Manual del usuario
Servicio de atención al Cliente
US: 1-800-645-2986
Portable Air Conditioner
Model 292850 10,000 BTU, Cool Only, 115V
Model 292851 12,000 BTU, Cool Only, 115V
Model 292852 14,000 BTU, Cool with Heat, 115V
• DO NOT plug other appliances into the same outlet.
• DO NOT disassemble or modify the air conditioner or
the power cord.
• DO NOT place the unit or its power cord near a heater,
radiator, or other heat source.
• DO NOT use unit near flammable gases/liquids or other
combustible substances; such as gasoline, benzene,
thinner, etc.
• ALWAYS grasp the plug when plugging in or unplugging
the air conditioner. Never unplug by pulling on the cord.
• DO NOT start or stop operation by plugging in or
unplugging the power cord.
• DO NOT use the air conditioner if it is emitting smoke or
an unusual order, unplug it immediately.
• DO NOT operate with wet hands or in a damp environment.
• DO NOT clean with water. Water can enter the unit and
damage the insulation, creating a shock hazard. If water
enters the unit, unplug immediately and contact Global
Industrial Customer Service.
• Use caution when removing or reinstalling the filter.
• DO NOT block the air inlet or outlet of the air conditioner.
Reduced air flow will result in poor performance and
could damage the unit.
• ALWAYS turn off and unplug the air conditioner when
it will not be used for an extended period of time. This
conserves energy and reduces the chance or accidents.
• Secure the wheels with wheel locks to prevent the air
conditioner from rolling on smooth floors.
• Close all doors and windows to the room for the most
efficient operation.
• To prevent damage to the surface finish, use only a soft
cloth to clean the air conditioner. Do not use solvents,
or any strong detergent to clean.
• Dispose of the water from the drain pan properly
outdoors or down a drain.
• Clean the filter every two weeks, or more often
if needed.
1
globalindustrial.ca
Manuel de l'utilisateur
Service à la clientèle
Canada: 888-645-2986
062019