Installation Instructions - Global Industrial 292850 Manual Del Usuario

ACCESSORIES
Note: all the illustrations in this manual are for explanatory purposes
only. Your appliance may be slightly different.

INSTALLATION INSTRUCTIONS

Exhausting Hot Air
In the Cool Mode the appliance must be placed close to a window or opening
so that the warm exhaust air can be ducted outside. First, position unit on a
flat floor and make sure there's a minimum of 18" (45cm) clearance around the
unit, and is within the vicinity of a single circuit outlet power source.
1. Extend either side of the hose (Fig.1) and screw onto the hose (Fig.2).
2. Extend the other side of the hose and screw it to the hose outlet (Fig.3).
3. Install the hose inlet into the unit (Fig.4).
4. Affix the hose outlet into the window slider kit and seal. (Fig.5 & 6).
Fig. 4 (A)
2. Lock
1. Slide Onto
Your window slider kit has been designed to fit most standard vertical and
horizontal window applications. However, it may be necessary for you to
modify some aspects of the installation procedures for certain types of
windows. The window slider kit can be fastened with screws.
NOTE: If the window opening is less than the minimum length of the
window slider kit, cut the end without the hole in it short enough to fit in the
window opening. Never cut the window kit attachment piece with the vent
hose hole in it.
Portable Air Conditioner
Parts
Window Slider Kit
Remote Control/Battery
Slide Onto
Part Name
Exhaust Hose
Hose Outlet
Hose Inlet
Exhaust Hose
Hose Outlet
Hose Inlet
Fig. 4 (B)
3
Quantity
1 Set (A)
Model 292851
Model 292852
1 Set (B)
Model 292850
1 Set
1 Set
Fig. 1
Extend the side of hose
Fig. 2
A
or
B
Fig. 3
Cut on opposite
side of hole
User's Manual