Global Industrial 292850 Manual Del Usuario página 5

Vertical
Window
Window
Slider
Fig. 5
Window Slider Kit Installation
1. Parts:
A. Panel
B. Panel with one hole
C. Screw to lock window kit in place
2. Assembly: Slide Panel B into Panel A and size to window width. Window sizes
vary. When sizing the window width be sure that the window kit assembly is
free from gaps and/or air pockets when taking measurements.
3. Lock the screw into the holes that correspond with the width that your window
requires to ensure that there are no gaps or air pockets in the window kit
assembly after installation.
4. Use the provided foam window kit sealer to close any gaps or air pockets.
Fig. 8
1. Cut the foam seal (adhesive type) to the proper length
and attach it to the window sash.
2. Attach the window slider kit to the window sash. Adjust
the length of the window slider kit according to the width
of window. If necessary, mark the kit and cut one end
down to properly fit the window.
3. Cut the foam seal (adhesive type) to the proper length
and attach it on the top of the window.
Portable Air Conditioner
Window Slider Kit
Foam
Seal
Window
Slider Kit
Window
Slider Kit
Foam
Seal
Horizontal
Window
Window
Slider
Fig. 6
Cut on opposite side of hole
Foam
Window
Slider Kit
Window
Slider Kit
Foam
4. Close the window securely against the window slider kit.
5. Secure the window slider kit to the window sash.
6. Cut the foam seal to an appropriate length and seal
the open gap between the top window frame and outer
window frame.
4
User's Manual
Fig. 7
Seal
Seal