Dongcheng DSP05-180 Manual Del Usuario página 10

noise emission value(s) have been measured in
accordance with a standard test method and may be
used for comparing one tool with another.
The declared vibration total value and the declared
noise emission value(s) may also be used in a
preliminary assessment of exposure.
A warning:
− that the vibration and noise emissions during actual
use of the power tool can differ from the declared
values depending on the ways in which the tool is
used especially what kind of workpiece is processed
; and
− of the need to identify safety measures to protect
the operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it is
running idle in addition to the trigger time).
Intended use
This product is suitable for polishing wood
surface,painted wooden furniture surface,synthetic
resin and hard rubber products,painted metal surface
polishing.
1. Switch Lock Button
3. Wool Bonnet
Additional safety rulesfor sander polishers
General safety warnings for all operations
a) This power tool is intended to function as asander
polisher, sanding machine, and wire brush.Read
all safety warnings, instructions, illustrations and
specifications provided with this power tool.
b) Do not use accessories which are not specifically
designed and recommended by the tool
manufacturer.
c) The rated speed of the accessories must be at
least equal to the maximumspeed marked on the
power tool.
d) The outside diameter and the thickness of your
accessory must be within the capacity rating of
your powertool.
e) The arbor size of wheels, flanges or any other
accessory must properly fit the spindle of thepower
tool.
EN
10
1
2
3
2. Switch Button
f) Do not use a damaged accessory. Before each use,
inspect the accessory such as abrasive wheels for
chips and cracks, backing pad for cracks, tear or
excess wear, wire brush for loose or cracked wires.
If power tool or accessory is dropped, inspect for
damage or install an undamaged accessory. After
inspecting and installing an accessory, position
yourself and bystanders away from the plane of
the rotating accessory and run the power tool at
maximum no-load speed for one minute.
g) Wear personal protective equipment. Depending
on application, use a face shield, safety goggles
or safety glasses. As appropriate, wear dust mask,
hearing protectors, gloves and workshop apron
capable of stopping small abrasive or work piece
fragments.
h) Keep bystanders a safe distance away from work
area. Anyone entering the work area must wear
personal protective equipment.
i) Position the cord clear of the spinning accessory.
j) Never lay the power tool down until the accessory
has come to a complete stop.
k) Do not run the power tool while carrying it at your
side.
l) Regularly clean the power tool's air vents.
m) Do not operate the power tool near flammable
materials.
n) Do not use accessories that require liquid coolants.
Further safety instructions for all operations
a) Maintain a firm grip on the power tool and position
your body and arm to allow you to resist kickback
forces. Always use auxiliary handle, if provided, for
maximum control over kickback or torque reaction
duringstart-up. The operator can control torque
reactions or kickback forces, if proper precautions
are taken.
b) Never touch the spinning accessory.
c) Do not stand nearby when the power tool
kickbacks.
d) Do not attach a saw chain woodcarving blade or
toothed saw blade.
e) Becareful when you work around sharp corner and
sharp edge. Avoid the accessories from bouncing
and twining.
SAVE THESE INSTRUCTIONS.
WARNING! MISUSE or failure to follow the safety
rules stated in thisinstruction manual may cause
serious personal injury.
INSTRUCTIONSFOR
OPERATION
Installing or Removing the Wool Bonnet
CAUTION:
Be sure that the tool is switched off and unplugged
when installing or removing the rubber pad.
To install the wool bonnet, first remove the dirtonthe