Dongcheng DSP05-180 Manual Del Usuario página 12

but also reduces the amount of dust and fine particles
being drawn into the tool.
Inspecting and replacing the carbon brushes
Remove and check the carbon brushes regularly.
Replacewhen they wear down to the limit mark(6mm
or 4 inch) . Keep the carbonbrushes clean and free
to slip in the holders. Both carbonbrushes should be
replaced at the same time. Use only identical carbon
brushes.
1.Limit Mark
1
Use a screwdriverto remove the brush holder caps.
Take outthe worn carbon brushes, insert the new
ones and securethe brush holder caps.
Maintenance of themotor
The motor unit winding is the very "heart"of the power
tool. Exercise due care to ensure the winding does
not become damaged and /or wet with oil or water.
Usage of theAuxiliary Handle
The auxiliary handle( M10) and the auxiliary handle(
Type D)can be used alternately according to different
occasions and operation habits.
1
2
※If the replacement of the supply cord is necessary,
this has to be done by the manufacturer or his agent
in order to avoid a safety hazard.
※To maintainproduct SAFETY and RELIABILITY,
repairs, anyother maintenance or adjustment should
be performed byauthorized service centers, always
usingoriginalreplacement parts.
EN
12