Dongcheng DSP05-180 Manual Del Usuario página 11

rubber pad.Then fix the spindle bypushingthe spindle
lock and tighten the abrasive disc on the spindle.
Install the wool bonnet onto the rubber pad.
When removing the wool bonnet, pull it from
the rubber pad, then fix the spindle by pushing
thespindlelock t, and loosen the.
1
2
Switch Action
To start the tool, simply pull the switch trigger.
Release the trigger to stop.
For continuous operation, pull the trigger and then
push in the lock button. To stop the tool from the
locked position, pull the trigger fully and thenrelease
it.
CAUTION:
Before plugging in the tool, always check to see that
thetool is switched off.
1
2
Speed Adjusting
The tool speed can be changed between 600rpm and
3500 rpm by turning the constant speedand power
controlto a givennumber setting from 600to 3500. (At
the timewhen the switch trigger is fully pulled.)
Higher speed is obtained when the dial is turned in
the direction of number 3500. And lower speed is
obtained when it isturned in the direction of number
600.
Refer to the table for the relationship between the
numbersettings on the dial and the approximate tool
speed.
1
1.Spindle
2.Wool Bonnet
1.Switch Lock
Button
2.Switch Button
1.Constant
Speed and Power
Controller
Number
600
1000
1400
1800
2200
2600
3000
3500
CAUTION:
If the tool is operated continuously at low speeds for
along time, the motor will get overloaded, resulting in
toolmalfunction.
●The speed adjusting dial can be turned only as far
as 600and back to 3500. Do not force it past 600or
3500, or the speedadjusting function may no longer
work.
●Polishing with wool bonnet using polishing
compound and/or wax. Apply a small quantity of
compound and/or wax on material surface and polish
with the wool bonnet.
MAINTENANCEAND
INSPECTION
CAUTION:
Always be sure that the toolis switched off and
unplugged before carrying out any work on the tool.
Cleaning Ventilation Slots
0For safe and properworking, always keep thepower
tool and its ventilation slots clean.Clean the
ventilation slots regularly or when they're clogged.
1
Inspecting the mounting screws
Regularlyinspect all mounting screws and ensure that
they are properly tightened. Should any of the screws
be loose, retighten them immediately. Failure to do
so could result in serious hazard.
After Use
Do not put down the tool as soon as it is turned off.
Wait until the tool has completely stopped turning
before putting it down. It not only avoids accidents,
Speed (/min)
600
1000
1400
1800
2200
2600
3000
3500
1.Air Outlet
2.Air Inlet
2
EN
11