Wall mounting the
center speaker
The center speaker have a mounting hole which
can be used to mount the speaker on the wall.
Before mounting
Remember that the speaker system is heavy and
that its weight could cause the screws to work
loose, or the wall material to fail to support it,
resulting in the speaker falling. Make sure that
the wall you intend to mount the speakers on is
strong enough to support them. Do not mount on
plywood or soft surface walls.
Mounting screws are not supplied. Use screws
suitable for the wall material and support the
weight of the speaker.
>
,
Caution
y If you are unsure of the qualities and
strength of the wall, consult a professional
for advice.
y Pioneer is not responsible for any accidents
or damage that result from improper
installation.
Mounting screw
(not supplied)
5 mm to 7 mm
large non-skid pads
5 mm
10 mm
Additional notes on
speaker
Rear
Install the main front left and right speakers at an
equal distance from the TV.
Precautions:
Front
Make sure that all the bare speaker wire is twisted
together and inserted fully into the speaker
terminal. If any of the bare speaker wire touches the
back panel it may cause the power to cut off as a
safety measure.
The front, center and surround speakers supplied
with this system are magnetically shielded.
However, depending on the installation location,
colour distortion may occur if the speaker is
installed extremely close to the screen of a
television set. If this case happens, turn the power
switch of the television set OFF, and turn it ON after
15 min. to 30 min. If the problem persists, place the
speaker system away from the television set.
The subwoofer is not magnetically shielded and
so should not be placed near a TV or monitor.
Magnetic storage media (such as floppy discs and
tape or video cassettes) should also not be kept
close to the subwoofer.
Do not attach the front/surround speakers and
subwoofer to a wall or ceiling. They may fall off and
cause injury.
Connecting
19
thick cord
Plastic catch
2