Descargar Imprimir esta página

Slime Pro Serie Manual Del Usuario página 2

Ocultar thumbs Ver también para Pro Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

Ensure that the vehicle is outside, or in an open, well-ventilated area and NOT INSIDE A
CONFINED AREA, SUCH AS A GARAGE as bodily injury or asphyxiation resulting in death
could occur. Always operate the inflator in a well-ventilated area free of combustible
materials, gasoline, or solvent vapors. Always set parking/emergency brake and ensure
vehicle is in Park (or neutral if equipped with manual transmission).
CAUTION: HOT • DO NOT HOLD IN HAND WHILE OPERATING
NOTICE: ENGINE SHOULD BE RUNNING WHILE USING THIS INFLATOR
It is recommended that you operate your inflator with your vehicle's engine running to
achieve the optimal inflator performance. Never start the vehicle while the inflator is
connected to the battery.
• Do not attempt to disassemble inflator.
• No user serviceable parts inside.
• Keep inflator out of reach of children.
• Place inflator on a hard, clean surface.
• Ensure air hose chuck touches the core of the valve stem for proper inflation.
• DO NOT use inflator continuously for more than 10 minutes. Allow unit to cool approximately 25 minutes
between uses. Do not leave inflator unattended.
• ALWAYS use a pressure gauge to check tire pressure. DO NOT over-inflate.
• Soft inflatables (i.e. rafts, balls, etc.) may not have recommended pressure markings. Be careful not to
inflate items beyond their capacity.
• While operating, never block the inflator input or output.
• Make sure connections and terminals are free of corrosion, debris, etc.
• To reduce risk of electrical shock or electrocution, do not disassemble the tire inflator.
• Do not use this product in an area where it can fall into liquids or bodies of water.
• The tire inflator is not intended to be hard-wired to your vehicle's 12V DC system.
• The 12V direct connect clips should be stored in secure manner when not in use; do not leave 12V direct
connect clips connected to battery while vehicle is in motion.
• For use with 12-volt DC batteries.
TECH SPECS
TIRE INFLATION TIME
CFM (LPM)
IN-LINE DIAL GAUGE
COIL AIR HOSE LENGTH
POWER CORD LENGTH
POWER SOURCE
TOTAL REACH
* (0-35 PSI, Standard Tire: P195/65 R15)
VEHICLE EXHAUST WITHOUT PROPER VENTILATION IS
EXTREMELY DANGEROUS. ALWAYS ALLOW FOR PROPER
VENTILATION.
1.5 min*
2.5 CFM (70.8 LPM) @ 0 PSI
PSI 0-150, BAR 0-10
22 ft. (6.7 m)
8 ft. (2.4 m)
Direct connect to battery
33 ft. (10 m)

Publicidad

loading

Productos relacionados para Slime Pro Serie

Este manual también es adecuado para:

Pro power 40048