Slime Pro Serie Manual Del Usuario página 4

REMOVING THE LIGHT
1. Using the finger-grip depressions found on the top and bottom surfaces of the removable
light, grab the light and pull firmly straight out to remove it from the inflator.
2. When finished, push the light firmly back into place until it clicks, confirming the light is
seated in the inflator.
REPLACING THE LIGHT BATTERIES
The removable light uses (2) AAA batteries which can be replaced when depleted.
1. Using the finger-grip depressions found on the top and bottom surfaces of the removable
light, grab the light and pull firmly straight out to remove it from the inflator.
2. Remove the light back panel cover by pulling it away from the main light housing, exposing
the interior components and batteries. There is a finger clearance area on the light housing
to aid in this step. Be careful not to move or remove any components other than the
batteries.
3. Remove depleted batteries and replace with new.
4. Carefully reinstall the back panel cover while holding the batteries in place until the cover
snaps into place.
5. When finished, push the light firmly back into place on the inflator until it clicks, confirming
the light is properly seated within the inflator housing.