Publicidad
Slide the Power Switch to power the Swing Control Module.
EN
The Speed Selector function provides 6 speed settings and OFF. The LEDs
operate sequentially and in bar graph mode. To start the swing function, press
the button until the flashing LED bar graph displays the desired setting. Then
gently push the seat (within 15 seconds) to activate the swing motion. After five
seconds, a single LED will indicate the selected speed.
When you change the speed setting during swing motion, the LED bar graph
will flash for five seconds during the speed adjustment. When the swing timer
expires, the swing stops and the Speed Selector and Timer LEDs turn OFF.
Use the Swing Timer Select function to turn OFF the swing automatically. Press
the button to sequence to the desired timer setting of 30, 45, or 60 minutes.
The three LEDs above the button indicate the selected time period. If you do
not select a timer setting (all LEDs are OFF), the unit uses a default time of 90
minutes for auto-shutoff. To use the swing function after auto-shutoff, either
press the Swing Timer Select Button or the Speed Selector Button.
Press the Nature Sounds/Music Button to begin music and nature sounds
playback. Press as needed to select the desired nature sound or song. Auto-
shutoff occurs after about 20 minutes.
Push the Volume Control Switch as needed to turn off or adjust the volume for
music and nature sounds.
The Low Battery Detection function detects weak batteries and suspends
normal swing operation, music, and nature sounds. The Low Battery Indicator
turns ON (red) when you press a button during this condition. To restore normal
operation, replace all batteries with new alkaline size D batteries.
– 25 –
Publicidad
