Makita UH004G Manual De Instrucciones página 11

2. Remove the cover and the plate.
Fig.10
► 1 . Cover 2. Plate
NOTE: The plate may remain on the cover.
3. Remove the rod and the bearing.
1
2
Fig.11
► 1 . Rod 2. Bearing
NOTE: The rod may remain on the cover.
4. Remove 2 bolts, the felt pad and the sleeves, and
then remove the shear blades.
1
2
Fig.12
► 1 . Felt pad 2. Bolt 3. Sleeve 4. Shear blades
5.
Remove the blade cover.
6.
Attach the blade cover to the new shear blades.
7. Adjust the crank so that 2 holes are lined up on
the alignment line.
Fig.13
► 1 . Hole 2. Alignment line
8. Align the protrusions on the shear blades vertically
at the same position.
Fig.14
► 1 . Protrusion
11 ENGLISH
1
2
3
2
1
4
1
1