Makita UH004G Manual De Instrucciones página 13

14. Attach the cover, and then tighten 6 bolts.
1
Fig.20
► 1 . Bolt 2. Cover
NOTICE:
If the shear blades do not move
smoothly, the shear blades are not engaged with
the rods properly. Install the shear blades again.
NOTICE:
If the parts other than the shear
blades such as the rods are worn out, ask Makita
Authorized Service Centers for parts replacement
or repairs.
Installing or removing the chip
receiver
Optional accessory
CAUTION:
When installing or removing the
chip receiver, always wear gloves so that your
hands do not directly contact the shear blades.
NOTICE:
For UH004G/UH005G/UH006G/UH007G
The blade cover cannot be installed if the chip
receiver is installed on the tool. Before carrying
or storing the tool, uninstall the chip receiver,
and then install the blade cover to avoid blade
exposure.
NOTICE:
For UH004G/UH005G/UH006G/UH007G
Be sure to remove the blade cover before install-
ing the chip receiver.
The chip receiver gathers discarded leaves and makes
clean-up afterward much easier. It can be installed on
either side of the tool.
1.
Hook the claws of the chip receiver to the shear blades.
2
Fig.21
► 1 . Claw
2. Align the holes on the chip receiver with the
screws on the shear blades, and then attach the chip
receiver to the shear blades securely.
Fig.22
► 1 . Hole
NOTICE:
Make sure that the chip receiver does
not overlap the branch catcher.
1
Fig.23
► 1 . Branch catcher
13 ENGLISH
1
1