Descargar Imprimir esta página

Beper P102FRU500 Manual De Instrucciones página 7

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 17
EN
Blender Use instructions
This appliance is for household use only.
To protect against electric shock, do not immerse cord, plug or any
parts of the appliance into water or other fluids.
Do not use the appliance near explosives, highly flammable mate-
rials, gases or burning flames.
Do not allow children, disabled people or every pe-
ople without experience or technical ability to use
the appliance if they are not properly watched over.
Close supervision is necessary when any appliance
used by or near children.
Use advice
When using the appliance make sure to stand it on a horizontal sur-
face.
Do not use the appliance in a continuous way for more than 1 minute.
Wait for another 1 minute before switch on again the appliance.
The intern blades are very sharpen ; be careful and manipulate the
blades carefully.
Do not touch parts of the appliance when moving.
Do never let the appliance working without supervision.
Do not try to remove the mixture from the bowl when the blades are
moving. Always wait for complete stop.
Do never immerge the motor, plug or supply cord into water or other
liquids.
For cleaning use a wet cloth.
Components Fig.A
1. Cap
2. Jar lid
3. Graduated jar
4. Blades
5. Motor unit
6. Speed selector (PULSE 0,1,2)
Instruction for use
Make sure the appliance is plugged and the speed selector is on position "0".
Put the graduated jar on the motor unit in the correct way.
Cut fruits and vegetables in pieces and out the ingredients into the jar with water or milk. Do not exceed the
maximum capacity of the jar, that is to say 1500ml.
Put the cap on the lid . Place the lid on the jar. Plug the blender to the socket.
Switch on the blender by pressing the speed selector in position "Pulse", position "1" for low speed and speed
"2" for high speed.
When finished and desired consistence obtained, switch off the blender by pressing the speed selector in posi-
tion "0" and unplug it from the socket.
7

Publicidad

loading