Joyello JL-1009 Manual De Instrucciones página 12

All manuals and user guides at all-guides.com
JL-1009/1010/1011
GB
FITTING INTO THE CAR - GROUP 0+ (For children from 0 to 13 kg)
REARWARDS FACING ONLY
Warning: DO NOT place the child seat in the front seat if equipped with air bags.
Otherwise, in the event of an accident, it may cause serious injury or death.
NOTES: The car safety belt must be pulled tight, making sure that it is not twisted. Ensure the
airbag is disconnected.
Step 1
Group 0 - the car seat should only be used in the most reclined position. (See fig. 1/a).
The child seat should never be used in any other position (fig. 1/b).
To adjust the seat to the maximum inclination for group 0, pull the red handle (J) forward until it
stops. The car seat must be used for group 0, only rear-facing and fully reclined, the only position
allowed. (Fig.2)
Step 2
The seat must always be rear facing (Fig. 3).
If your car has a passenger airbag that cannot be deactivated, only use the car seat in the back seats
of the vehicle (Fig. 1/c).
Step 3.
Secure the child car seat on the car seat using the car seat belt (see Fig. 3).
The loops where the car seat belts need to be inserted, both over lap and shoulder, are marked with
blue symbols for group 0.
Step 4.
Lead the lap section of the seat belt under the base of the child seat at the two points marked by a
blue label (A).
Pass the shoulder part of the belt in the upper runner at the top of the backrest.
Secure the car seat belts to the fastening mechanism M to the corresponding buckle (M). (See fig. 5)
Step 5.
Put your child in the safety seat and place the harness that was previously fastened, over the child.
Fasten the buckle (G) by joining the two parts of the belt (E and F) together until you hear a click (Fig.
6/a). Adjust the tension of the straps to the child's body so that they are tight but not restraining, the
seat is equipped with a central belt (H): if you pull the strap, the child seat belt system is tightened
until it fits on the child's body snug. Make sure the car seat belts are not twisted and that they are flat.
To loosen the straps, press the metal button with one hand and with the other hand pull the straps
toward you at the same time (Fig. 6/b)
12