Publicidad
Step 8
Carefully turn your unit over onto its front edges. Unfold
å
the BACK (D) and lay it over your unit.
Make equal margins along all four edges of the BACK (D).
å
Push on opposite corners of your unit if needed to make
it "square".
Fasten the BACK (D) to your unit using the NAILS (1N).
å
Using your hammer, gently tap six TACK GLIDES (13E)
å
into the ENDS (A2 and B2) and BASE (I).
NAIL
(38 used in this step)
A2
13E
13E
These two TACK GLIDES
should be fl ush with the
front surface of the BASE.
Page 12
1N
I
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
D
B2
13E
420850
This hole must be here.
www.sauder.com/service
Publicidad
