Proxxon WB 220/E Instrucciones De Servicio página 7

Working with the drill
Important:
Risk of injury. Do not operate this drill
unless you are wearing protective
goggles.
Never work with damaged grinding
discs or bent shanks.
Replace dull insert units promptly.
In the event of heavy dust ratio or
harm ful dust particles, wear a dust
mask.
1. Switch drill on at switch 2 (Fig. 3)
and select the appropriate speed at
dial 1.
Never use excessive bearing pressure.
Correct, uniform speed facilitates opti -
mum grinding.
Small milling cutters/shanks =
high speed
Large milling cutters/shanks =
low speed
2. Hold drill as shown in Fig. 4 so as
not to obstruct the ventilation slits 1.
If the drill overheats, switch it off
im me diately and allow it to cool.
Note:
Note:
Disposal:
Please do not dispose of the device in
domestic waste! The device contains
valuable substances that can be
recycled. If you have any questions
about this, please contact your
local waste management enterprise
or other corresponding municipal
facilities.
EC Declaration of Conformity
We declare that this product conforms
with the following EC guidelines:
• EG-low voltage regulation
2006/95/EWG
DIN EN 60745-1 / 06.2007
DIN EN 60745-2-1 / 06.2007
• EC-EMV-regulation 2004/108/EWG
DIN EN 55014-1 / 06.2007
DIN EN 55014-2 / 08.2002
DIN EN 61000-3-2 / 10.2006
DIN EN 61000-3-3 / 06.2006
• EC machine regulation
2006/42/EWG
DIN EN 60745-1 / 06.2007
DIN EN 60745-2-1 / 06.2007
Dipl.-Ing. Jörg Wagner
10.03.2009
PROXXON S.A.
Equipment Safety Division
- 7 -