JUNO JDIF907E0 Manual De Uso página 57

The time of saturation of the charcoal filter
varies depending on the type of cooking
and the regularity of cleaning the grease
filter.
To replace the filter:
1. Remove the grease filters from the
appliance.
Refer to "Cleaning the grease filter" in this
chapter.
2. press the tab (1) and slightly tilt the
front of the filter.
1 1
3. To install a new filter, perform the
same steps in reverse order.
In any case, it is necessary to replace the
filters at least every four months.
TROUBLESHOOTING
WARNING! Refer to Safety
chapters.
What to do if...
Problem
You cannot activate the ap‐
pliance.
You cannot activate the ap‐
pliance.
The lamp does not operate.
All manuals and user guides at all-guides.com
Possible cause
The appliance is not con‐
nected to a power supply or
it is connected incorrectly.
The fuse is blown.
The lamp is defective.
Filter alarm
Refer to activating and
deactivating the filter alarm in
daily use chapter.
Refer to cleaning the grease
filter in this chapter.
Refer to cleaning the charcoal
filter or replacing the charcoal
filter (depends on filter type).
To reset the alarm:
Touch the for 3 seconds.
Replacing the lamp
This appliance is supplied with a LED
lamp. This part can be replaced by a
technician only. In case of any malfunction
refer to "Service" in the "Safety
Instructions" chapter.
Remedy
Check if the appliance is
correctly connected to the
electrical supply.
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Replace the lamp. Refer to
the "Care and Cleaning"
chapter
57