Publicidad
Idiomas disponibles
Idiomas disponibles
Care and Maintenance
Freezer
Compartment
Lamp
Dispenser Lamp
Freezer
Compartment
Shelf
Door Rack and
Support
Ice Storage Bin
After Dispenser
Is Used
All manuals and user guides at all-guides.com
How to Dismantle Parts
NOTE
Dismantling is done in the reverse sequence of assembly.
•
Be sure to unplug the power plug before dismantling and assembly.
Never apply severe force to dismantle parts. Parts may be damaged.
Remove cover by pressing upward on bottom
and rotating outward
Turn the bulb counterclockwise. Max. 40 W bulb
for refrigerator is used and can be purchased at
a service center.
Seperate the lamp by pulling it out, and then
remove the lamp. Max. 15 W bulb for
refrigerator is used and can be purchased at a
service center.
To remove a shelf, Lift the left part of the
shelf a bit. Lift it to the direction , push the
right part to the direction , and take it out.
Lift the door rack holding both sides
pull it out to
direction.
Lift the ice shelf as shown in the right figure
and pull it out .
Hold the ice storage bin as shown in the right
figure and pull it out
It is recommended not to dismantle the ice
storage bin unless it is necessary.
Use both hands to remove the ice bin to avoid
dropping it.
If the ice bin does not slide into place easily,
twist the drive device slightly.
The water collector has no self-draining
function. It should be cleaned regularly.
Remove the cover by pulling the front side of
water collector cover and dry it with a cloth.
20
6
.
and
while slightly lifting it .
Care and Maintenance
2
1
"
!
Publicidad
