Bosch 0 601 9L0 001 Manual Original página 15

Technical Data
Orbital sander
Article number
Rated voltage
A)
No-load speed
A)
No-load orbital stroke rate
Orbit diameter
Sanding plate dimensions
– Square
– Rectangular
– Triangular (sanding sheet
length from corner to
corner)
Weight according to EPTA-
B)
Procedure 01:2014
Recommended ambient
temperature during charging
Permitted ambient temper-
C)
ature during operation and
during storage
Recommended rechargeable
batteries
Recommended chargers
A) Measured at 20–25 °C with rechargeable battery GBA 12V
3.0Ah.
B) Depends on battery in use
C) Limited performance at temperatures < 0 °C
Values can vary depending upon the product and are subject to ap-
plication and environmental conditions. For further information
www.bosch-professional.com/wac.
Noise/Vibration Information
Noise emission values determined according
to EN 62841-2-4.
Typically, the A-weighted sound pressure level of the power
tool is 71.0 dB(A). Uncertainty K = 3 dB. The noise level
when working can exceed the volume stated. Wear hearing
protection!
Vibration total values a (triax vector sum) and uncertainty K
h
determined according to EN 62841-2-4:
2 2
a = 3.6 m/s , K = 1.5 m/s
h
The vibration level and noise emission value given in these
instructions have been measured in accordance with a
standardised measuring procedure and may be used to com-
pare power tools. They may also be used for a preliminary
estimation of vibration and noise emissions.
The stated vibration level and noise emission value repres-
ent the main applications of the power tool. However, if the
power tool is used for other applications, with different ac-
cessories or is poorly maintained, the vibration level and
noise emission value may differ. This may significantly in-
Bosch Power Tools
GSS 12V-13
3 601 JL0 0..
V= 12
–1
min 6000–10,000
–1
min 12,000–20,000
mm 1.6
mm 100 x 110
mm 80 x 130
mm 100 x 150
kg 1.0 kg (1.5 Ah)–1.2
kg (6.0 Ah)
°C 0 to +35
°C –15 to +50
GBA 12V...
GAL 12...
GAX 18...
crease the vibration and noise emissions over the total work-
ing period.
To estimate vibration and noise emissions accurately, the
times when the tool is switched off or when it is running but
not actually being used should also be taken into account.
This may significantly reduce vibration and noise emissions
over the total working period.
Implement additional safety measures to protect the oper-
ator from the effects of vibration, such as servicing the
power tool and accessories, keeping their hands warm, and
organising workflows correctly.
Rechargeable battery
Charging the battery
Use only the chargers listed in the technical data. Only
u
these chargers are matched to the lithium-ion battery of
your power tool.
Note: Lithium-ion rechargeable batteries are supplied par-
tially charged according to international transport regula-
tions. To ensure full rechargeable battery capacity, fully
charge the rechargeable battery before using your tool for
the first time.
Inserting the Battery
Push the charged battery into the battery holder until it
clicks into place.
Removing the Battery
To remove the rechargeable battery, press the battery re-
lease button and pull the battery out. Do not use force to do
this.
The rechargeable battery has two locking levels to prevent
the battery from falling out if the battery release button is
pressed unintentionally. The rechargeable battery is held in
place by a spring when fitted in the power tool.
Battery charge indicator
The battery charge indicator (5) on the power tool consists
of three green LEDs. It indicates the battery's state of charge
for a few seconds after the power tool is switched on and off.
LED
Continuous lighting 3 x green
Continuous lighting 2 x green
Continuous lighting 1 x green
Slowly flashing light 1 x green
The three LEDs in the battery charge indicator flash
quickly when the temperature of the battery is outside
the operating temperature range of -30 to +70 °C and/or
the overload protection has been triggered.
Recommendations for Optimal Handling of the
Battery
Protect the battery against moisture and water.
English | 15
Capacity
60–100%
30–60%
10–30%
0–10%
1 609 92A 8W7 | (03.07.2023)