Bosch 0 601 9L0 001 Manual Original página 17

The required orbital stroke rate is dependent on the material
and the work conditions and can be determined using prac-
tical tests.
The Constant Electronic keeps the orbital stroke rate at no
load and under load virtually consistent, guaranteeing uni-
form performance.
Application Overview
Range of applications
Sanding plate – Sanding surfaces and corner spaces
80 x 130 mm
– Sanding rebates in windows and doors
– Sanding old paint and varnish
– Sanding wood
– Sanding solid wood edges and veneer edges
Sanding plate – Sanding surfaces and corner spaces
100 x 110 mm
– Sanding rebates in windows and doors
– Sanding old paint and varnish
– Sanding wood
Sanding plate – Sanding slats
100 x 150 mm
– Sanding rebates and profiles
– Removal from surfaces with angles, corners
and edges
– Sanding old paint and varnish
– Sanding wood
Working Advice
Remove the battery from the power tool before carry-
u
ing out work on the power tool (e.g. maintenance,
changing tool, etc.). The battery should also be re-
moved for transport and storage. There is risk of injury
from unintentionally pressing the on/off switch.
Always wait until the power tool has come to a com-
u
plete stop before placing it down.
The material removal rate when sanding is primarily determ-
ined by the choice of sanding sheet and the preselected or-
bital stroke rate .
Only immaculate sanding sheets achieve good sanding per-
formance and make the power tool last longer. Switch the
power tool on, place the entire sanding surface against the
surface of the workpiece and apply moderate pressure as
you move the sander over the workpiece.
Be sure to apply consistent contact pressure in order to in-
crease the lifetime of the sanding sheets.
Excessively increasing the contact pressure will not lead to
increased sanding performance, rather it will cause more
severe wear of the power tool and of the sanding sheet.
Do not use a sanding sheet for other materials after it has
been used to work on metal.
Use only original Bosch-sanding accessories.
Bosch Power Tools
After working at a low orbital stoke rate for an extended
period, you should operate the power tool at the maximum
orbital stroke rate for approximately three minutes without
load to cool it down.
Application Abrasive
Coarse sanding P40–P180
Fine sanding P220–P400
Coarse sanding P40–P180
Fine sanding P220–P400
Coarse sanding P40–P180
Fine sanding P220–P400
Maintenance and Service
Maintenance and Cleaning
Remove the battery from the power tool before carry-
u
ing out work on the power tool (e.g. maintenance,
changing tool, etc.). The battery should also be re-
moved for transport and storage. There is risk of injury
from unintentionally pressing the on/off switch.
To ensure safe and efficient operation, always keep
u
the power tool and the ventilation slots clean.
After-Sales Service and Application Service
Our after-sales service responds to your questions concern-
ing maintenance and repair of your product as well as spare
parts. You can find explosion drawings and information on
spare parts at: www.bosch-pt.com
The Bosch product use advice team will be happy to help you
with any questions about our products and their accessor-
ies.
In all correspondence and spare parts orders, please always
include the 10‑digit article number given on the nameplate
of the product.
Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham Uxbridge
UB 9 5HJ
English | 17
Speed setting
4–6
1–3
4–6
1–3
4–6
1–3
1 609 92A 8W7 | (03.07.2023)