Publicidad
Idiomas disponibles
Idiomas disponibles
JUMPER (JP3)
The following Jumper allows to adjust the line termination (Z) in case of in-out video door phone connection.
The line termination must be inserted into the last video door phone.
JP3
For position of jumpers JP1 and JP2 and dip-switch SW1 no.1 refer to the next chapter of the following
handbook.
4.
VIDEO DOOR PHONE PERFORMANCE ACCORDING TO
CONFIGURATION METHOD
The video door phone can be configurated with 3 different methods. Depending on the selected method,
limitation will be present on the following performance.
Performance
Jumpers and DIP-
switches
Delay time on
reception of call
forwarding to CallMe
app
CallMe app auto-on
Panic alarm signalling
to CallMe App
Emergency call from
the CallMe App
Automatic door
opener timing
6
Termination inserted (default)
Termination not inserted
Low rise block (Default)
(Power supply from
system BUS with WiFi
always active)
JP1
JP2
SW1 n.1
O N
=
No delay
Available
Available
Not available
Not available
Installation type (*)
High rise block
(Power supply from
system BUS with
WiFi active after call
forwarding)
JP1
JP2
SW1 n.1
O N
O N
O N
=
=
=
10 seconds
Not available
Not available
Not available
Available
Local power
(Power supply from
local power supply unit
Ref. 1760/110)
JP1
JP2
SW1 n.1
O N
=
No delay
Available
Available
Available
Available
DS1760-047B
O N
=
Publicidad
