Makita 9031 Manual De Instrucciones página 4

FUNCTIONAL DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Switch action
CAUTION:
• Before plugging in the tool, always check to see
that the switch trigger actuates properly and
returns to the "OFF" position when released.
► 1. Lock button 2. Switch trigger
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
Speed adjusting dial
► 1. Speed adjusting dial
The belt speed can be infinitely adjusted between 3.3
m (656 ft./min.) and 16.6 m (3,280 ft./min.) per second
by turning the speed adjusting dial to a given number
setting from 1 to 6.
Higher speed is obtained when the dial is turned in the
direction of number 6, lower speed is obtained when it
is turned in the direction of number 1. Select the proper
speed for the workpiece to be sanded.
•
ASSEMBLY
•
Installing side grip
1
2
► 1. Side grip 2. Grip holder
For your own safety, always use the side grip. Install
it by screwing it firmly on the grip holder. The side grip
can be pivoted for easy operation.
Installing or removing abrasive belt
1
► 1. Rear pulley 2. Front pulley
Loop the belt over the front pulley. Hold the tool as
shown in the figure and press down to retract the front
pulley so that you can slip the other end of the belt over
the rear pulley. When pressing down the tool, be careful
not to allow the front pulley to turn unexpectedly, caus-
ing you to lose control of the tool.
NOTE:
•
4 ENGLISH
CAUTION:
The speed adjusting dial can be turned only as far
as 6 and back to 1. Do not force it past 6 or 1, or
the speed adjusting function may no longer work.
CAUTION:
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
2
1
2
The arrow on the inside of the belt and that
marked on the rear pulley must point in the
same direction.
1