Bosch 0.615.990.EN6 Manual Original página 16

OBJ_BUCH-1279-004.book Page 15 Thursday, October 17, 2013 11:52 AM
Assembly
Battery Charging (Accessory)
 Use only the battery chargers listed on the accessories page. Only these bat-
tery chargers are matched to the lithium ion battery of your cordless worklight.
Note: The battery is supplied partially charged. To ensure full capacity of the battery,
completely charge the battery in the battery charger before using your power tool for
the first time.
The lithium ion battery can be charged at any time without reducing its service life. In-
terrupting the charging procedure does not damage the battery.
The lithium ion battery is protected against deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is empty, the cordless worklight is switched off
by means of a protective circuit.
 Do not continue to press the On/Off switch after the cordless worklight has
been automatically switched off. The battery can be damaged.
To remove the battery 4, press the battery unlocking button 5 and pull the battery to-
ward the rear out of the cordless worklight. Do not exert any force when doing this.
Observe the notes for disposal.
Operation
Initial Operation
Inserting the battery
Insert the charged battery 4 into lamp head 3 until it can be felt to engage and faces
flush against the lamp head 3.
Switching On and Off
To start the cordless worklight, press the On/Off switch 2.
To switch off the cordless worklight, press the On/Off switch 2 again.
To save energy, only switch the cordless worklight on when using it.
Temperature Dependent Overload Protection
When exceeding the allowable heat-sink temperature of 60 °C, the cordless worklight
flashes 3x and then switches off. Allow the cordless worklight to cool down, then
switch the cordless worklight on again.
Bosch Power Tools
English | 15
1 609 92A 0DJ | (17.10.13)