ASA Electronics JHD40BT Manual De Instalación Y Funcionamiento página 9

TUNER OPERATION
NOTE: The key pad may vary slightly in shape depending on the model and revision
Select a Band
Press the BAND/SEARCH button (16) to change between three FM bands and two AM (MW)
bands.
Manual Tuning
Press the SEEK/TUNE/TRK / ◄◄ or
stations up/down step by step.
Auto Seek Tuning
Press and hold the SEEK/TUNE/TRK / ◄◄ or
to automatically seek the next or previous strong station.
Preset Stations
Six numbered preset buttons store and recall stations for each band.
Store a Station
Select a band (if needed), then select a station. Press and hold a preset button (5-10) for two
seconds. The preset number will appear in the display.
Recall a Station
Select a band (if needed). Press a preset button (5-10) to select the corresponding stored
station.
SEEK/TUNE/TRK / ►► buttons (13, 14) to seek
SEEK/TUNE/TRK / ►►buttons (13, 14)
Automatically Store / Preset Scan (AS/PS
Automatically Store
Select an AM or FM band. Press and hold the AS/PS
to automatically select strong stations and store them in all bands. The new stations replace any
stations already stored in that band.
NOTE: During Auto Store (AS), the tuner will default to "Local" mode while scanning the
band initially. After scanning the entire band once, the unit will switch to "Distant" mode
for all subsequent Auto Store tuning.
Preset Scan
Select a band (if needed). Press the AS/PS
The unit will pause for ten seconds at each preset station. Press AS/PS
scanning when the desired station is reached.
9
)
button (15) for more than three seconds
button (15) to scan stations stored in all bands.
again to stop