BaByliss PRO 4rtists BOOST+ FX7870GBPE Manual Del Usuario página 8

at the end of trimmer and plug the
adapter into power outlet.
ON/OFF SWITCH
To operate, simply slide switch to
«I» position. To stop operation, set
to the «0» position.
VERY IMPORTANT:
MUST BE CLEANED AND OILED
ON A REGULAR BASIS FOR PRO-
PER FUNCTIONING. FAILURE TO
REGULARLY CLEAN AND OIL THE
BLADES WILL VOID THE WAR-
RANTY.
REPLACING (REMOVING) BLADE
SET
To remove the blade set, turn the
trimmer to the OFF position and
unplug it from the electrical outlet.
Turn the trimmer upside down so
that the teeth of the trimmer are
facing down. Place the trimmer
on a flat surface and using the
screwdriver, loosen the fastening
screws from the blade set. Remove
the blade set from the trimmer
(see Fig. 1).
Fig. 1
Blade set
Blade screws
To install or replace your trimmer
blade set, reverse the procedure,
aligning the blade cushion shaft
into the moving blade cushion
(see Fig. 2). With the blade held in
place, replace blade screws and
tighten loosely. Turn the trimmer
over and align the blade set paral-
lel to the trimmer's upper housing
Fig. 2
BLADES
Moving blade
Fixed blade
Screw holes
BLADE CARE
Because the trimmer blades are
precision-made for a very special
use, they should always be handled
with care and cleaned regularly to
ensure maximum performance.
Each time you finish using the trim-
mer, take the cleaning brush provi-
ded and brush away any loose hair
that has collected in the blades. Use
a clean cloth to dry the attachment,
reattach and then store the trim-
mer to protect the blades until the
next use.
Any other servicing should be per-
formed by an authorized service
representative, since the appliance
has no other user-serviceable parts.
This product is for professionall
use.
DO NOT RINSE BLADE OR TRIM-
MER HANDLE OR ADAPTER.
8
Screws
Screws
Blade cushion