Frizzlife PX500-A Manual Del Propietário página 7

Model: PX500-A
Fig.3
Step 3: Connect the water supply (COLD WATER ONLY)
Shut off the water supply. (Fig.7)
Disconnect the cold water pipe from angle valve.
Twist the feed water valve onto the angle valve and make sure the O ring is
loaded. (Fig.8)
Connect cold water pipe onto the feed water valve. (Fig.9) Valve installation
complete.
Fig.7
Step 4: Connect the "SUPPLY" water tubing
Except " DO NOT USE" one, remove all other three plugs by pressing the
fitting sleeves. (Fig. 10)
Connect the other end of 3/8" tubing into "Supply" port on the back of the system,
make sure to insert the tubing about 0.8 inch to the end of the fitting. ( Fig.11)
Put the lock clip on the fitting to secure the connection. (Fig.12)
Fig.4
Fig.8
Fig.5
Fig.9
EN
Fig.6