Fired Up Corporation OKO S1 Manual De Seguridad página 13

FITTING AN INSET FIRE
Installing the fire where a stone or marble back panel is used
570mm
1. For solid walls,
drill the 2 holes
approximately
35mm deep using
a 6mm diameter
drill bit. Note if
fitting the fire to
plaster board with
a cavity behind
then propriety wall
fixings (not
supplied) will be
required.
3. Pass cable tie
through the larger
hole on the fire
body trim,
ensruing that the
head of the cable
tie does not pass
through this hole.
5. Threading the
cable tie
through the
second hole in
the fire body,
and attach
through the
main head of
the tie, pulling to
the left to
tighten the fire
into postition.
2. Insert wall plug
into wall, then
tighten the hook
screwthread into
the wall plug.
4. Pass cable
tie through the
hook of
the threaded
insert, in a
clockwise
direction.
6. Once the
cable tie has
has sufficent
tension
applied, the
excess cable
can be pushed
neatly through
the larger hole
to be
concealed out
of view.
1 3