Status Light; Status Led - Vetus WPANEL Manual De Uso

Controlador de limpiaparabrisas
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 16
SPEED function switch
Whenever the SPEED switch
is pressed, the next wipe programme is
selected.
The available programmes are:
1 interval 11 sec,
2 interval 9 sec,
3 interval 7 sec,
4 interval 5 sec,
5 interval 3 sec,
6 continuous low speed,
7 continuous high speed.
Once programme 7 is reached, pressing
the switch selects programme 1 again.
After a different programme is selected,
the status lamp indicates the new setting
by means of a series of flashes (1 to 7);
this series is repeated once. See p. 23
'Using the SPEED button'.
On first use and each time after the cur-
rent is switched off, the windshield wipers
will wipe at low speed.
If the current has not been switched off,
the wipers will wipe at the last interval set-
ting or speed selected, unless the last
setting was the highest speed.
The wiper motors can be operated auto-
matically if rain sensors have been instal-
led; consult the manual supplied with the
rain sensors.
Windscreen spray switch
Pressing the
switch once will run the
wipe/wash programme completely auto-
matically:
- 3 seconds of spraying
- at least 3 wipes with simultaneousspray-
ing,
- 3 final wipes.
Pressing the
6
101002.01
SPEED
switch and keeping it
pressed will maintain wiping with simul-
taneous spraying. All wipers will wipe,
regardless of the position of the wiper
switch.

Status light

The status light
of the function
tes the wiper controller status:
On: wiper controller is active,
Off: wiper controller is not active,
Fast flashing: current is too low or there is
an internal fault,
Two series of flashes: selected program-
me indicated.
This is shown if a different programme is
set and after the wiper controller is swit-
ched on.

Status LED

The status LED on the con-
troller unit (between the +
and – battery terminals)
shows the status of the
wiper controller:
- Green: the wiper controller is active,
- Flashing green: the current is too low,
- Red: internal fault,
- Off: the wiper controller is not active.
Windscreen wiper controller
SPEED
switch indica-
-
STATUS
159

Publicidad

Tabla de contenido
loading

Tabla de contenido