Publicidad
Idiomas disponibles
Idiomas disponibles
3. Liquids may be emptied through the tank
drain. To empty, turn the Unit off and remove
the plug from the wall outlet. Remove the
drain cap and deposit the liquid waste
conents in a suitable drain. After tank is
empty, return the drain cap to its original
position. To continue use, plug the cord into
the wall outlet and turn the unit on.
BLOWING OPERATION
WARNING!
Always wear safety goggles complying with ANSI Z87.1 (or in
Canada CSA Z94.3) when using as a blower.
WARNING!
To avoid injury to bystanders, keep them clear of blowing debris.
CAUTION
Wear a dust mask if blowing creates dust which might be inhaled.
CAUTION
To reduce the risk of hearing loss, wear ear protectors when
using the vac/blower for extended hours or when using it in a
noisy area.
Your vac contains a blowing feature. It has the capability to blow
sawdust and other debris. It can be used to blow dust and debris
out of garages or off patios and driveways. Follow the steps
below to use your vac as a blower.
1. Locate blowing port on your vac.
2. Insert one end of the 2-1/2 in. x 7 ft. hose
into the blowing port.
3. Turn vac "ON".
CARE AND MAINTENANCE
FILTER REPLACEMENT
WARNING!
To reduce the risk of injury from accidental starting, unplug power
cord before changing or cleaning filter.
Your filter should be cleaned often to maintain peak vac
performance.
IMPORTANT
To avoid damage to the blower wheel and motor, always reinstall
the Clean Connect
filter before using the vac for dry pickups
TM
and wet pickups.
IMPORTANT
After cleaning, check the filter for tears or small holes. Do not use
a filter with holes or tears in it. Even a small hole can cause a lot
of dust to come out of your vac. Replace it immediately.
NOTE
Before installing the filter on the vac, clean the area of the lid so
that the filter will seal against the lid and stop small particles from
bypassing the filter bag. If the filter is clean and not damaged, replace
it on the filter cage. If it cannot be reused,place a new filter over the
filter cage.
NOTE
Clean the filter in an open area. Cleaning should be done outdoors
and not in living quarters.
WARNING!
Do not remove filter cage and float. The float prevents water from
entering the impeller and damaging the motor. The cage prevents
fingers from touching the moving impeller.
10
Publicidad
