Publicidad
Idiomas disponibles
Idiomas disponibles
INFORMATION ON SAFETY DECALS
CAUTION
1. Become familiar with the Owners Manual before attempting to operate this equipment.
2. Do not allow children to operate this equipment. Do not operate this equipment in the vicinity of
bystanders.
3. Do not allow hands or any other part of the body or clothing inside the feeding chamber, discharge
chute or near any moving part.
4. Before inspection or servicing any part of the machine, switch off the machine, disconnect the mains
plug from the machine and make sure all moving parts have come to a complete stop.
5. Do not transport the machine while the motor is running.
6. Avoid wearing loose-lifting-clothing.
7. Operate the machine only on a level surface, keep proper balance and footing at all times, do not
operate machine on a paved or gravel surface.
8. Before starting the machine, check that all screws, nuts, bolts and other fasteners are properly
secured; make certain that the cutting chamber is empty. Do not operate without guards or screens
in place.
9. When feeding shred-able material into the equipment, be extremely careful that pieces of metal,
rocks, bottles, cans or other foreign objects are not included.
10. Obtain and wear safety glasses at all times while operating machine.
11. If the cutting mechanism strikes any foreign object or if the machine should start making any unusual
noise of vibration, immediately switch off the machine and allow the machine to stop. Disconnect the
mains plug from the machine and take the following steps:
1) Inspect for damage.
2) Replace or repair any damaged parts.
3) Check for and tighten any loose parts.
12. Keep the motor clean of debris and other accumulations.
13. Do not allow processed material to build up in the discharge area this may prevent proper discharge
and can result in kickback of material through the discharge opening.
14. Keep all guards and deflectors in place and in good working condition. Replace any damaged decals.
15. Always stand clear of the discharge area when operating this machine. Keep face and body back
from the feed opening.
16. If the machine becomes clogged, switch off the machine, disconnect the mains plug wire and allow
machine to come to a complete stop before cleaning debris.
DANGER
ROTATING CUTTING BLADES
KEEP HANDS AND FEET OUT OF INLET AND DISCHARGE OPENINGS WHILE MACHINE IS
OPERATING TO AVOID SERIOUS PERSONAL INJURY. STOP ENGINE, REMOVE SPARK PLUG
WIRE AND ALLOW MACHINE TO COME TO A COMPLETE STOP BEFORE CLEARING
OBSTRUCTIONS OR MAKING ADJUSTMENTS.
DANGER
SHIELD HAS BEEN REMOVED.
DO NOT OPERATE WITHOUT SHIELD IN PLACE. SERIOUS INJURY OR EDATH MAY OCCUR.
CAUTION
READ ALL THE SECTIONS IN THISMANUAL PRIOR TO ATTEMPTING TO SERVICE, MAINTAIN OR
OPERATE THIS EQUIPMENT.
DO NOT OPERATES THIS EQUIPMENT UNTIL YOU HAVE READ AND UNDERSTOOD ALL THE
ENCLOSED OPERATOR'S MANUAL.
7
ENGLISH
Publicidad
