Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARATION
The following parts must be in the packaging before the shredder can be assembled:
• Shredder
• Filling hopper and feed intake tube.
• Operating instructions with warranty card. If contrary to expectations a part is missing, please
contact your nearest BENZA Service Station.
REASSEMBLE THE SHREDDING OPENING (Fig.1)
• Place the filling hopper and deflector on the top
flange of the shredder intake opening. Screw the
filling hopper tight with 4 hexagon screws through
the hopper flange, the deflector and the intake
opening flange.
• Place the feed intake tube with filling hopper on the
shredder housing in such a way that the two holes
of upper bracket tongues fit into the corresponding
holes of lower bracket tongues on shredder housing.
• Screw the intake opening tight with two hexagon
screws, 4 nylon bushes and 2 lock nuts through four
holes.
• Lock the feed intake tube to shredder housing by
locking handle.
ATTENTION:It is not possible to use the
shredder without the feed intake tube
in right place, a safety switch interrupts
the current to the motor. If the motor still
continues to run after the feed intake opening
has been removed, the safety switch should
be check by an expert.
FOR YOUR SAFETY
WARNING:Switch off, remove plug from mains before adjusting, cleaning or if
cable is cut, damaged or entangled.
CAUTION:do not touch rotating blades.
For electric motor operation:Check the connection lead regularly for signs of damage and ageing
only use if it is in perfect condition.
• Keep connecting cables away from the ejector device. Switch off motor and remove plug before
working in the shredder disc, checking the connecting and cleaning the devices.
• The couplings of the connection cable must be made of rubber or covered with rubber and
must comply with the DIN/VDE 0620 standard.
Porca de
bloqueio
Cavilha
Bucha de
nylon
Fig.1
15
ENGLISH
Silo de
enchimento
Defletor
Tubo de entrada
Cavilha
Bucha de
nylon
Porca
Manivela de bloqueio
Publicidad
