Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
• The connection socket must be provided with a slow-blowing 16 amp fuse.
• The electrical fittings of the waste shredder should not be altered.
• Any damages parts must be replaced.
• If the shredder is left for any length of time the plug should always be removed from the mains
socket.
• Make sure that the cable is not bent or caught.
• It is recommended that residual current devices with a nominal fault current of a maximum 0.03
amperes or similar protective devices be used fault current breaker with a maximum release
current of 30 mA is connected upstream.
NOTE:THE PLUG OF THE CONNECTING CABLE MUST BE PROTECTED FROM SPLASH
WATER. FOR WARRANTY AND SAFETY REASONS ONLY ORIGINAL BENZA PARTS, IN
PARTICULAR SHREDDER BLADE, ARE TO BE USED.
FEATURES AND CONTROLS
Filling hopper
Chipping chute
On/Off switch and
emergency stop
Plug-in socket
RIGHTS TO MAKE TECHNICAL ALTERATIONS RESERVED!
Wheel
16
Feed intake tube
Locking handle
Safety switch
Discharge chute
Electric motor
Publicidad
