Publicidad
Idiomas disponibles
Idiomas disponibles
Accessories
3D Eyewear (1)
Be sure to attach the provided ferrite core to the charging cable to reduce interference or electrical noise.
1. Attach the ferrite core as close to USB connector of the charging cable as shown.
2. Close the ferrite core until it clicks.
1. Turn off the television power, and set the 3D Eyewear power switch to "OFF".
2. Connect as shown in the diagram, and turn on the television power.
• The indicator lamp lights red, and charging starts.
• When the indicator lamp turns off, charging is complete.
(Approximately 2 hours required)
3. Turn off the television power, and remove the charging cable.
Note
●
Be sure to turn the television power on when charging. The battery will not be charged when the television power is
off.
All manuals and user guides at all-guides.com
3D Eyewear case (1)
Attaching Ferrite Core
Mini USB connector
USB connector
Charging the 3D Eyewear
Mini USB connector
Charging cable (1)
Ferrite core
USB connector
(1)
23
Publicidad
