Publicidad
Idiomas disponibles
Idiomas disponibles
PACkING LIST
Pressure Washer
25 ft. High Pressure Hose
Trigger Handle
Spray Wand
Quick-Connect Nozzle (3)
Soap Blaster
Nozzle
™
Injection Hose with Filter
4-Cycle Engine Oil (SAE 30 or SAE 10W30)
Handle
Nozzle Holder with Spring Clip
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
INSTALLING THE HANDLE
See Figure 2.
Push and hold the button on the handle as you slide the
handle into the holes in the frame.
NOTE: Before use, pull the handle up until the lock
button snaps through the locking slot to secure the handle
in place.
ATTACHING INJECTION HOSE
See Figure 3.
Before detergent can be used with this machine, the injection
hose must be attached.
Open the cap from the detergent container.
From the top of the cap, slide the injection hose through
the hole in the cap.
ASSEMBLy
Push the injection hose filter onto the end of the injec-
tion hose and pull enough hose through the cap so the
injection hose filter will rest at the bottom of the detergent
container (or detergent bottle).
Close the cap on the detergent container.
Push the open end of the clear injection hose securely
over the fitting as shown in figure 3.
NOTE: Keep injection hose away from hot surfaces by push-
ing the hose into the clip in the frame.
ASSEMBLING THE TRIGGER HANDLE
See Figure 4.
Place the threaded end of the spray wand in the connector
on the end of the trigger handle.
Turn the connector clockwise until it stops. This secures
the spray wand in place.
CONNECTING HIGH PRESSURE HOSE TO
TRIGGER HANDLE
See Figure 5.
Screw the collar on the high pressure hose into the
trigger handle inlet coupler by turning the hose collar
clockwise.
Pull on the hose to be certain it is properly secured.
CONNECTING THE HIGH PRESSURE HOSE
TO THE PUMP
See Figure 6.
After the high pressure hose has been uncoiled and attached
to the spray wand:
Align the collar on the threaded nipple on the pump.
Insert the nozzle on the end of the high pressure hose
collar into the threaded nipple.
Turn the collar clockwise to tighten the hose securely to
the pump.
Pull on the hose to be certain it is properly secured.
CONNECTING THE GARDEN HOSE TO THE
PRESSURE WASHER
See Figure 7.
CAUTION:
Always observe all local regulations when connnecting
hoses to the water main. Some areas have restrictions
against connecting directly to public drinking water sup-
ply to prevent the feedback of chemicals into the drinking
water supply. Direct connection through a receiver tank
or backflow preventer is usually permitted.
8 — English
Publicidad
